Publicité
Les langues disponibles
Les langues disponibles
ALARM ACTIVATION ON DOORS CLOSING
It's possible to be activated only with the instantaneous buttons input or with the buttons
detected by the original datas transmission "CAN" (also refer to the assembly instructions).
By pressing the locking button of the original remote control with an open door, the system
signals the denial on activation giving 3 BEEPS and 3 LED flashings followed by a continuous
hiss from the buzzer. Only the door closing stops the signal and activates the alarm system,
even if the door is not locked.
PRE-ALARM
Needed to avoid short unwanted alarms with vehicles where the alarm system desactivation in
security requires some seconds, to complete all the necessary checks.
When activating this function, all the intrusion as well as doors, bonnet and boot opening alarms
are preceded by a hiss from the buzzer. If the system is not correctly desactivated within 5 / 8
seconds, the normal alarm signaling is activated.
ALARM OUTPUT
It has to be kept fix in case of an electronic siren or if it's paired to the satellite protection,
otherwise intermittent only if it's used to control the vehicle klaxon.
INSTANTANEOUS / DELAIED BUTTONS INPUT
On the system activation the input can be instantaneous or delayed (
becomes instantaneous). It must be delayed when the signal is taken by the delayed switching
off internal roof lamp or if are used the additional modules (anti lifting, high frequency, etc).
The set up depends on the vehicle model and on the paired accessories).
FIXED / ADDITIONAL MODULES CUTTING OUT / TIMED STATUS SIGNAL OUTPUT
- FIXED:
To enable a sensor which is always active with the system engaged.
- CUTTING OUT: To not enable an additional sensor if the windows are opened or there is
person or animal on board.
- TIMED:
With vehicles having a "comfort" equipment (simultaneous windows closing
by turning the original key in the door lock block), it is possible "to automate"
the windows closing on the system activation using the status output as
timed, according to the vehicle's features.
If the output is set to CUTTING OUT or TIMED, by engaging the system with the temporary
cutout of the radar sensor and the additional modules, the output will not be available.
NOT ENABLED RECOGNITION [+15] BY CAN
Avoids reading of [+15] ON (panel key signal on, engine running) by the original "CAN" line of
the vehicle.
The analogue line will be permanently on (Orange wire).
RESETTING OF THE INITIAL CONDITIONS PROGRAMMED AT DEFAULT
It allows to restore the original condition of the central unit, resetting all the default
programmings.
MAINTENANCE
The central unit does not need any maintenance.
WARNING: When washing the engine, protect the electronic siren adeguately.
WARRANTY CONDITIONS
The technical warranty has a duration of 24 months from the date of installation, ex-works, and
covers those parts considered as defective only by A.E.B. S.p.A.
Any other external labor or extra costs are excluded.
18
or
30
50 seconds
then it
Publicité
