Publicité
Les langues disponibles
Les langues disponibles
If any anomalies or alarms occurred, the first alarm is shown by some additional signalings
(BEEPS) of the siren and by some LED flashings:
Doors, bonnet, boot openings detected on "CAN" line.
1
Contact key [
2
+15] ON
Ultrasonic sensor (it detects all kind of intrusions in the vehicle).
3
Doors, bonnet, boot and additional modules on analogical line.
4
Anti-tampering of the ultrasonic sensor (anti-blinding/anti-masking).
5
The boot lid opens, if separately detected on the "CAN" line (or only 1 signal).
12
The bonnet lid opens, if separately detected on the "CAN" line (or only 1 signal).
13
The alarm memory is repeated if the system is activated and desactivated without
turning the contact key on [+15] ON.
It's cancelled only by turning the contact key [+15] ON.
To simplify the use of the system, we always suggest the pairing of the electronic key CHD 400
(allowing the system activation / desactivation without the remote control and the vehicle start).
Offers a complete range of accessories specifically designed to be paired with this central unit
and to complete the vehicle protection such as, for example: hyperfrequency, shock sensors;
accessory warning horns, sat protection systems controlled either by a Monitoring Centre or
directly by the user (do it yourself).
Ask your installer for more
:
WARNING
The acoustic signals for: on / off, refusal, alarm log, pre-alarm, electronic key use,
!
programming, etc. are only available with the SIR 050.
The installer has to give to the vehicle owner the
!
and the
INSTALLATION CERTIFICATE
warranty (to keep on board).
Some functions could cut out others.
!
The central unit has to be installed by skilled personnel.
!
A.E.B. S.p.A. declines all responsibility and suspends the warranty in case of any
!
inappropriate use of the product, in case of tampering or pairing with inappropriate devices.
Place the central unit in the cockpit with cables coming from below, far from strong heat
!
sources, protected from liquid infiltrations or condensate.
A.E.B. S.p.A. reserves the right to bring any kind of improvements without previous notice.
!
DENIAL ON ACTIVATION
With the contact key in on position, the central unit ignores the remote control and the
!
electronic key.
and
3 BEEPS
3 flashings
!
the buttons input is set as INSTANTANEUS even if they are detected by the CAN line.
Close the door and activate the system again.
If the alarm is activate on the closing doors the 3 BEEPS are followed by a long continuous
buzzer BEEP that ends only when all doors are closed.
The alarm is activated automatically.
If the input is
DELAYED
pre set delay time (
and
5 BEEPS
5 flashings
!
PROGRAM the system to activate it again.
.
.
of the LED mean that the door, the bonnet or the boot are opened if
and the door is not closed the system is ACTIVATED, then after the
or
seconds) the system carries out an alarm cycle.
30
50
of the LED mean that the system is OUT OF ORDER.
PIN CARD
duly filled out and signed, that is valid as product
, THESE
USER'S GUIDE
11
Publicité
