Publicité
Les langues disponibles
Les langues disponibles
OPERATION MANUAL AND INSTRUCTIONS
NON PERMISSIBLE USE
Do not:
- Use the hoist if all the indications included in the general warnings
are not respected.
- Use the hoist if the nameplate and/or markings are missing and / or
unreadble.
- Use the hoist if it and his components are not in good condition.
- Use the hoist if the chain or the hooks are not correctly fitted.
- Use the hoist if any of safety devices are not correctly operating or
damaged.
- Extend the actuating lever of the hoist.
- To tamper to adjust the overload protection system (if any).
- Fit the hoist by any means other than its suspension hook.
- Clamp the suspension hook.
- Use the hoist for purposes or configurations other than the ones
described in this user manual.
- Motorize the hoist or operate it in a different way than indicated.
- Clean the hoist using a high pressure cleaning devices and/or using
aggressive chemical products (i.e. acids chlorinated products).
- Use the hoist exceeding the WLL value.
- Use the hoist in environment with temperatures out of the range
-10°C ÷ 50°C.
- Use the hoist to lift load in environment where the wind speed could
compromise his stability.
- Use the hoist to lift or move people.
- Use the hoist in an explosive or in corrosive environment.
- Try to lift or pull fixed or blocked loads.
- Use the hoist or load chain like a sling.
- Use the hoist like an electrical ground or electrical conductor.
- Apply the load to the hook end.
- To force the actuating lever when the lower end stop or the lifting
hooks are against the unit.
- Beat on the actuating lever.
- Set the selector lever in position "N" when the chain is tensioned.
- Pull sideways on loads to be lifted.
- Swing the load under the hoist.
- Stand or move around under the load.
- Intervene on the hoist without first having removed the load.
- Operate the knob when operating the hoist or when the chain is
tensioned.
DECLARATION OF CONFORMITY
We hereby declare, assuming full responsibility, that the described
product complies with all relevant provisions of Machine Directive
2006/42/CE and amendments thereto, as well as with the following
standard:
• EN 13157
The Technical File is available at:
BETA UTENSILI S.P.A. – Divisione Robur
Zona Industriale - C.da San Nicola
67039 Sulmona (L'Aquila)
ITALY
EN
11
Publicité
