Valve Clearance; Storage - Generac XD5000E Manuel Du Propriétaire

2. Disconnect positive (+) battery terminal
SECOND (B).
3. Loosen wing nuts and remove battery
bracket and hardware.
4. Replace battery by following instructions in
the "Battery Installation (if equipped)."
section.
A
Figure 4-5. Battery Connection
Inspect Muffler and Spark Arrestor
(if equipped)
NOTE: It is a violation of California Public
Resource Code, Section 4442, to use or
operate the engine on any forest-covered,
brush-covered,
unless the exhaust system is equipped
with a spark arrestor, as defined in Section
4442, maintained in effective working
order. Other states or federal jurisdictions
may have similar laws.
Contact original equipment manufacturer,
retailer, or dealer to obtain a spark arrestor
designed for exhaust system installed on this
engine.
NOTE: Use ONLY original equipment
replacement parts.
Inspect muffler for cracks, corrosion, or other
damage. Remove spark arrestor, if equipped,
inspect for damage or carbon blockage.
Replace parts as required.

Valve Clearance

IMPORTANT: If uncomfortable about doing
this procedure, or the proper tools are not
available, take generator to the nearest ser-
vice center to have valve clearance adjusted.
Check valve clearance after the first fifty-hours
of operation. Contact Authorized Service
Facility.
16
B
or grass-covered

Storage

General
It is recommended to start and run the genera-
tor for 30 minutes, every 30 days. If this is not
000716
possible, refer to the following list to prepare
unit for storage.
• DO NOT place a storage cover on a hot
generator. Allow unit to cool to room tem-
perature before storage.
• DO NOT store fuel from one season to
another unless properly treated.
• Replace fuel container if rust is present.
Rust in fuel will cause fuel system prob-
land
lems.
• Cover unit with a suitable protective, mois-
ture resistant cover.
• Store unit in a clean and dry area.
• Always store generator and fuel away from
heat and ignition sources.
Prepare Fuel System for Storage
Recoil Start
1. Push and hold decompression down and
slowly pull recoil starter 2 to 3 times. Do
not start engine.
2. Pull decompression lever up. Pull recoil
slowly until resistance is felt. This will
close valves so moisture cannot enter
engine cylinder. Gently release recoil.
Electric Start
1. Push and hold decompression lever down.
2. Push Start/Run/Stop switch to turn the
engine for 2 to 3 seconds. Do not start
engine.
3. Pull decompression lever up. Pull recoil
slowly until resistance is felt. This will
close valves so moisture cannot enter
engine cylinder. Gently release recoil.
4. Completely drain fuel tank or completely
fill fuel tank to proper level.
Operator's Manual for Portable Generator
DANGER
Explosion and Fire. Fuel and vapors are extremely
flammable and explosive. Store fuel in a well
ventilated area. Keep fire and spark away. Failure to
do so will result in death or serious injury.
WARNING
Risk of Fire. Verify machine has properly cooled
before installing cover and storing machine.
Hot surfaces could result in fire.
WARNING
Vision Loss. Eye protection is required to avoid
spray from spark plug hole when cranking engine.
Failure to do so could result in vision loss.
(000143)
(000109)
(000181)