Cisco Systems Linksys Guide WET54G v3 Guide D'installation Rapide page 2

Connect the Wireless-G Ethernet
1
Bridge for Setup
A
Attach the detachable
antenna.
B
Plug the included Ethernet
network cable into the LAN port
on the back panel of the
Bridge.
C
Plug the other end of the
Ethernet network cable into the
RJ-45 port of the hub, switch,
or PC you wish to use to
configure the Bridge.
D
Plug the supplied power
adapter into the Power port on
the back panel of the Bridge.
Then plug the other end into
an electrical outlet.
E
The Power LED will light up after
the Bridge is powered on. While
the Bridge is booting up and
performing a self-test, the
Power LED will flash. It should
stop flashing within twenty
seconds and remain lit.
2
B
D