Wine Cell'R PLATINUM WC34PLSZ5 Manuel D'instructions page 12

You also have the option of turning off the temperature digit display when the control panel
goes into sleep mode while locked. Simply press and hold the LIGHT button for 3 seconds;
the temperature digits will darken. If you hold down the LIGHT icon for 3 seconds, this
function will be reversed.
(b) Before you start
The wine cabinet must be installed in a location where the ambient temperature is between
60-80 °F or 15-27 °C. If the ambient temperature is outside this recommendation, the
performance of the wine cabinet may be affected. Installing your appliance in extremely
cold or hot conditions may cause temperature fluctuations inside your wine cabinet.
(c) Temperature setting
NOTE: The temperature reading indicates the actual temperature of the wine cabinet, it
temporarily displays the temperature set during the adjustments, then returns to the
temperature read inside after 5 seconds.
1. Make sure the power cord is properly connected to a grounded outlet.
2. Turn on the appliance.
3. Dual zone models: Use the zone select button to select the upper or lower zone. The
distance between the 2 zones should be between (7 °F or 4 °C) and (14 °F or 8 °C)
colder than the lower zone to optimize the performance of the wine cabinet.
4. Set the desired temperature by pressing the Temp ( + ) or ( - ) button.
5. Temperatures will increase or decrease by 1 °F or °C each time the Temp ( + ) or ( - )
button is pressed.
NOTE: Temperatures may fluctuate with interior lighting ON or OFF and
depending on bottles' position.
(d) Locking and unlocking the panel
To lock the control panel
1. Press and hold the button (padlock) for 3 seconds.
2. The control panel will emit a beep and a padlock will appear
at the right of the digits.
To unlock the control panel
1. Touch the panel to exit from standby mode.
2. Press and hold the button (padlock) for 3 seconds.
3. The control panel will beep and the padlock at the right of the numbers will disappear.
12