Disposal Of The Packaging; Inserting/Replacing The Battery - SilverCrest SSBS 3.0 A1 Mode D'emploi

Disposal of the packaging

The packaging materials have been selected
for their environmental friendliness and ease of
disposal, and are therefore recyclable. Dispose of
packaging materials that are no longer needed in
accordance with applicable local regulations.
Dispose of the packaging in an environmentally
friendly manner.
Note the labelling on the packaging and separate
the packaging material components for disposal if
necessary. The packaging material is labelled with
abbreviations (a) and numbers (b) with the
following meanings:
1–7: plastics, 20–22: paper and cardboard,
80–98: composites.

Inserting/replacing the battery

♦ Open the battery compartment on the rear of the remote
release . To do this, turn the battery compartment cover
e.g. with a coin, in the direction of the arrow OPEN until the
arrow on the battery compartment cover
open lock symbol
♦ Insert a CR 2032 battery into the battery compartment.
The positive terminal should face upwards.
♦ Replace the battery compartment cover
the remote release
To do this, turn the battery compartment cover
direction of the arrow CLOSE until the arrow on the battery
compartment cover
NOTE
► If the operating LED
battery is depleted and must be replaced.
│ GB │ IE │ NI
■ 8
.
and lock the battery compartment.
points to the closed lock symbol
flashes orange every second, the
points to the
on the back of
in the
SSBS 3.0 A1
,
.