Axis T93G Serie Guide D'installation page 12

AXIS T93G Series
Install the Housing to the Wall Mount
NO TICE NO NO TICE TICE
• Use cables that keep within the specified cable area, see page 8 . Using any other than
the provided cable gasket could cause water to seep in and damage the product. For
information about cable gaskets and cable glands that allow for other cable areas, see
www.axis.com
• If more than one cable is used, each cable must be routed through a separate cable gasket.
• Only open a hole in cable gaskets that will be used and if a cable gasket is torn, replace it
with a new cable gasket. Leaving a cable gasket open or using a torn cable gasket could
cause water to seep in and damage the product.
1. Loosen the bottom cover screws and lift the top cover.
2. Select which cable gasket to use and pull the tab to open a hole for the network cable.
1 Bottom cover
2
Bottom cover screw T20 (4x)
3
Cable gasket M20 (2x)
4
Tab
NO TICE TICE
NO NO TICE
If the network cable has a pre-mounted network connector, remove the cable gasket and
use the supplied connector guard to prevent tearing of the cable gasket. Avoid using
network cables with capped network connectors because they could cause tearing of the
cable gasket despite using the connector guard.
12