Monogram ZDT925 Manuel Du Propriétaire page 19

The 3rd rack is also removable to allow extra large items to be placed in the upper rack.
Rack
clips
To remove the 3rd rack:
1
Remove the silverware and utensil trays.
(See the IMPORTANT NOTES in this
section.)
To replace the 3rd rack:
1
Extend both side rails fully out of the
dishwasher.
2 Orient the rack so that its side clips are aligned
and centered with the posts on the side rail
and lower the clips onto the posts.
3 Move the rack to one side of the dishwasher
until the clips fall onto the posts.
Rack
clips
Rail
posts
Loading the Dishwasher
2
Push the rack all the way to one side so
that a gap between it and the side rail
forms on the other side. Align the side rail
posts with the center of the clips on the
rack and lift straight up.
Rail posts
on inside
of rails
Rail
3
Continuing to hold the rack in the lifted
position, repeat on the other side.
4 Once the rack is removed, push the side
rails all the way back into the dishwasher.
4
Continuing to hold the rack in the lifted
position, repeat on the other side.
5 Once the rack is replaced, pull it all the
way out to lock it in place in its side rails.
Rail
post
Rack
Rail
clip
6 Replace the silverware and utensil trays.
Dishwasher
Rack
clips
Rack
Push rack
to one side
Rail post
will slide
in or out
of this
opening
Rack
Pull rack all the way
out to lock it in place
Align rail posts
with rack clips -
Pull rack up
Rail
post
Rail
clip
19