Monogram ZDT925 Manuel Du Propriétaire page 11

Rinse agents, such as Finish
Use a Rinse
Aid are designed for great drying action and to
Agent
protect against spots and film build-up on your
dishes, glasses, flatware, cookware, and plastic.
Filling the Dispenser
The rinse agent dispenser holds
of rinse agent. Under normal conditions, this will
last approximately one month - depending on
setting.
1
2
3
4
5
Leak If a leak is detected, the dishwasher will drain
and the cycle will stop. The display will show
Protection
"LEAK DETECTED". Call for service.
Make sure the dishwasher door is fully open.
Open the Rinse Agent dispenser door.
Slowly add rinse agent until the cup is full. You
may need to pause several times to allow rinse aid
to settle. NOTE: Indicator window does not
light up.
Clean up any spilled rinse agent with a damp cloth
to prevent foam from forming inside the
dishwasher.
Close the Rinse Agent dispenser door.
Using the Dishwasher
Jet-Dry Rinse Rinse Aid Setting
® ®
The amount of rinse agent released into the final
wash can be adjusted. If water drops or hard
water spots remain on dishes after the dry cycle,
increase the setting.
3.5 oz. (104 ml)
To adjust the setting
Open the Rinse Agent dispenser
the adjuster clockwise to increase the amount
of rinse agent, counterclockwise to reduce the
amount of rinse agent.
Dishwasher
Rinse
agent
adjuster
Clockwise to Counterclockwise
reduce water to reduce foaming
drops and hard
water spots
door; then turn
11