CONTINENTAL EDISON CELED483DMLA3 Mode D'emploi page 65

• If your nose or temple turns red, or you feel pain
or discomfort, stop using the 3D glasses.
Such symptoms as above may occur if you keep
wearing them for a long time, which may also cause
indisposition.
• Be careful not to pinch your fingers in the hinge of
the 3D glasses.
3D Glasses
LCD Lens
Glasses Pairing Operation Instruction
These 3D Active glasses use Bluetooth wireless
technology. It is recommended to pair the TV to
the glasses before using to view 3D, as to prevent
interference from other Bluetooth devices. After
pairing the glasses will only work with the TV they
are paired to. There is no need to repeat this process
once successful pairing is complete unless you wish
to use with another TV.
To pair the glasses and TV:
1. Ensure TV is in 3D mode and glasses are within
0.5M of the TV.
2. In power on or power off state, press the power
button for 3 seconds. The LED light will flash
red and green whilst pairing is in progess.
Pairing success is indicated by the 3D glasses
shutters operating normally and the 3D content
can be viewed.
3. If the glasses cannot successfully pair with the
TV, the LED indicator will light red. If this is the
case, repeat steps 1 and 2 above.
Replacement of battery
• Push the spring clasp to the left, at the same time
move the battery lid up as indicated in picture 1.
• Pull the battery lid up. Install or replace the battery
as indicated in picture 2 observing correct polarity.
• Close the battery lid as shown in picture 3.
picture 1
picture 2
Operation Instruction and Function of
Power LED Light
Power on
• Ensure TV is in 3D mode
Spring
clasp
Battery lid
Power
button /
LED light
picture 3
• Press the power button on the glassesThe LED light
will flash red. Glasses are now in ON state
Power off
• Press the power button on the glasses
• The LED light will flash red. Glasses are now in
OFF state
Automatic Power off
If the glasses do not receive a Bluetooth signal from
the TV within 3 seconds, the glasses will automatically
shutdown, indicated by the LED light flashing red.
Low battery power
If the battery power is low, the LED light will flash
every 2 seconds and/or the glasses shutter will
work abnormally. In this case replace the battery as
indicated in the above section.
To ensure better 3D vision experience, please watch
within the suggested viewing range (Pairing range
≤0.5M).
Standard Specification
3D method Liquid Crystal Shutter
Dimensions Width: 147 mm
Height: 39 mm
Depth: 154 mm
Operating temperature: 0°C - 40°C
Weight (including battery): 28g ± 2g
Material Frame: Resin
Lens: Liquid crystal glass
Battery: CR1620; Battery life: 40hr +/- 5hr
The battery operating time may become shorter
depending on the
usage condition or environment.
Pairing range: < 0.5 m
Viewing range: 1-10 m
The specification may change without notice.
We herby declares that this product with an integrated
Wireless Function is in compliance with the essential
requirements and other relevant provisions of
Directive 1999/5/EC..
English - 64 -
Horizontal
View Range1-10m
view