CONTINENTAL EDISON CELED483DMLA3 Mode D'emploi page 52

720p@50 FP
Supported
720p@60 FP
Supported
1080p FC SBS, TB
720p FC SBS, TB
1080i FC
OTHER
Please note that if you apply 720p FC TB input; the picture
will be scaled smaller than the original size in the middle
of the screen.
SBS: Side By Side
TB: Top Bottom
MBP: Media Browser Picture
MBV: Media Browser Video
FC: Frame Compatible
FP: Frame Pack
in MBP: Supported only when, the image's height is
multiples of 2 and the image's width is multiples of 16 and if
the image width is equal to the panel width or wider.
in DTV: Supported only when, the image's height is between
1700 and 1900 and the image's width is equal to 1280 or 720.
(*): Not supported if the image provides 1080i resolution.
CONNECTIVITY FUNCTIONS
Wired Connectivity
To Connect to a Wired Network
• You must have a modem/router connected to an
active broadband connection.
• Ensure that Nero Media Home software is installed
to your PC.(for DLNA function). See Nero Media
Home Installation" section.
• Connect your PC to your modem/router. This can
be a wired or wireless connection.
• Connect your TV to your modem/router via an
ethernet cable. There is a LAN port at the rear
(back) of your TV.
Broadband ISP
connection
LAN (ethernet)
cable
Rear side of the TV
DTV ATV
Not
Not Supported Not Supported
Not
Not Supported Not Supported
Not Supported
Not Supported
SBS Not Supported
(*) Not Supported Not Supported
• To access and play shared files, you must select the
OTHER
Media Browser. Press the Menu button and select
Media Browser. Press OK to continue. Select the
desired file type and press OK. You must always
use the Media Browser screen to access and play
shared network files.
SBS, TB
• PC/HDD/Media Player or any other devices that are
SBS, TB
DLNA 1.5 compatible should be used with a wired
SBS
connection for higher playback quality.
To configure wired settings please refer to the
Network Settings section in the System>Settings
menu.
• You might be able to connect your TV to your LAN
depending on your network's configuration. In such
a case, use an ethernet cable to connect your TV
directly to the network wall outlet.
Configuring Wired Device Settings
Network Type
The Network type can be selected as Wired or Wireless,
in accordance with the active connection to the TV set.
Select this as "Wired" if you are connecting via an
ethernet.
Configuration Status
This section displays the status of the connection.
IP Address
If an active connection is available, the IP address will
be displayed on this section. If you want to configure
an IP address preferences, press the GREEN button
and switch to the advanced mode.
Configuring Wired Network Settings in
Advanced Mode
After pressing the GREEN button, the "Advanced
mode" will be available. While in Advanced Mode,
press the RED button to edit settings. When
finished, press OK to save, Press RETURN/BACK
to cancel.
Wireless Connectivity
To Connect to a Wireless Network
• To make your modem's SSID visible, you should
change your SSID settings via the modem's
software. The TV cannot connect to the networks
with a hidden SSID.
English - 51 -