Foster EcoPro G2 Manuel D'instructions page 4

GB
To exit this mode scroll back to the adjustment screen and press
the display will revert to the normal display showing the operating temperature.
Set Point and Other Mode Adjustments
Access the adjustment mode as described above. Using the
mode that requires adjustments i.e 'Set Point' this is the minimum temperature the cabinet is
allowed to cool down to (the display shows the temperature and flash/pulsing icon
To adjust this press and release
or switch. Confirm the change by pressing and releasing
automatically show.
Scroll through the modes with the
press and release to exit and save.
If at any point the display is left for 30 seconds it will revert to the normal display and no
changes will be saved.
Keypad Security Settings
Access the 'Keypad Security' screen as described above.
The screen will show the current status, initially preset to '
release and will show constantly. (If you modify this setting with
will be locked, will show constantly and the cabinet will not be able to be put into standby,
carry out a manual defrost, adjust temperature set point, download data or switch on/off the units
lights. To confirm any change you must press
Exit any of the 'Adjustment Modes' as described above.
Internal Light (where fitted)
To switch on the lights press and release
To switch off press and release
Shelves and Supports
G2 shelving for low, high or meat temperature cabinets consist of two trayslides per shelf. These
slot directly into the rear of the cabinet's airduct and have ladderacking to support the front.
Shelves are the standard wire gastronorm style that slide onto the trayslides. Fish cabinets come
with fixed racking and fish bins, wine cabinets with the required bottle racking/holder assembly.
Both of these are fitted instead of standard shelving.
Chef and Standard Drawers
To Remove a Standard Drawer
Pull out the drawer to its full extent. Lift the drawer body upwards and then retract the drawer
body towards you again.
Food
Cover all foods and separate raw and cooked foods to avoid cross contamination.
the icon will show constantly. Adjust the setting with the
or switch until you return to the adjustment screen and
again so the next screen '
so that the switch backlight is on continuously.
and the switch backlight will flash/pulse.
(on counter models only)
To Remove a Chef Drawer
Pull out the drawer to its full extent. Lift the side release
lever upwards (as shown in the 2nd diagram).
With the lever lifted the drawer can be removed from the
sliders and the counter.
or wait for 30 seconds and
or switches to scroll to the
again, the next mode will
', with flashing. Press and
to show '
' shows).
).
' the keypad
3