Know Your Product; Operation - SPARKY TK 70 Notice Originale

Know your product

Before using the power tool, familiarize your-
self with all the operating features and safety
requirements.
Use the tool and accessories only for the ap-
plications intended. All other applications are
expressly ruled out.
1. ON/OFF switch locking button
2. ON/OFF switch lever
3. Nut for fixing the cutting depth/ruler
4. Parallel guide/ruler
5. Thrust washer
6. Blade tightening screw
7. Parallel guide fixing nut
8. Clamping washer
9. Riving knife
10. Mobile guard
11. Screw for fixing the riving knife
12. Allen key
13. Nut for adjusting bevel cutting/ruler
14. Adapter
15. Screw
16. Washer
17. Screw
18. Saw blade

Operation

This power tool is supplied from single-phase al-
ternating current mains only. It is double insulat-
ed according to EN 60745-1 and IEC 60745 and
can be connected to grounded or not grounded
sockets. This power tool is radio suppressed in
compliance with EMC Directive.
This power tool is designed for longitudinal and
cross sawing wood in a straight line at bevel an-
gle from 0° to 45°.
PRIOR TO INITIAL OPERATION
▪ Make sure the power supply voltage corre-
sponds to the value indicated on the name
plate with technical data of the tool.
▪ Always check the position of ON/OFF switch.
The power tool must be connected to the
power supply socket only when this switch is
in OFF position. If the plug is connected to
a receptacle while the power switch is in the
ON position, the power tool will start operat-
ing immediately, which could cause a serious
accident.
▪ Make sure that the cord and the plug are in
order. If the replacement of the supply cord is
necessary, this has to be done by the manu-
8
EN
facturer or his agent in order to avoid a safety
hazard.
▪ Always inspect the blade. Use only well grind-
ed blades. Never use blades with cracks and
indents or HSS-blades.
▪ The riving knife must not touch the blade.
▪ Check if the mobile guard moves freely.
▪ Make sure the work piece or the material is
well secured.
WARNING: Always switch off and un-
plug the power tool prior to any adjustment,
servicing or maintenance or in case of mains
drop-out.
SWITCHING ON - SWITCHING Off
- Switching on: press locking button 1 and then
the lever of ON/OFF switch 2.
- Switching off: release the lever of ON/OFF
switch 2.
DUST EXTRACTION
The circular saw may be completed in addition
with dust capturing adapter. Place adapter 14 on
guard cover and fix it by screw 15 and washer
16. This adapter fits vacuum cleaners with Ø35
hose orifice.
Use a vacuum cleaner during operation. Con-
nect the vacuum cleaner to the machine adapter
and switch on the vacuum cleaner prior to start-
ing a cut. Clean the adapter at regular intervals
to ensure optimum dust extraction.
MOUNTING AND REPLACING THE
BLADE
WARNING: Draw the plug out of
mains socket!
The blade is covered by mobile guard 10 at rest
and during work. Turn the guard over and hold in
this position. Unscrew by Allen key screw 6, while
detaining clamping washer 8 by a spanner or by
placing the blade upon wood. Dismount washer
8 and blade. Mounting the blade is achieved in
reverse order. The supporting surfaces of thrust
washer 5, blade and clamping washer 8 must
be clean. The directions of arrows on the blade
and the immobile guard must correspond.
After replacing the blade and prior to work let
the machine operate at no-load for 30 seconds.
Vibrating blades must be replaced.
TK 70