sunjoe 24V-X2-PW1200 Manuel De L'opérateur page 19

Troubleshooting
• Remove the batteries from the compartment before carrying out maintenance on the machine or when checking that its parts
are in proper working order.
• To avoid unnecessary hassles, consult the following table before contacting customer service with any mechanical issues.
Problems
Machine refuses
to start
Fluctuating pressure
The error indicator
flashes and then
machine stops
Machine pulsating
Machine often starts
and stops by itself
Machine starts, but
no water comes out
Possible Cause
• Power failure/Batteries are not
inserted well
• Pump sucking air
• Valves dirty, worn out, or stuck
• Pump seals worn out
• Nozzle partially blocked
• Batteries are flat
• Air in inlet hose
• Inadequate supply of mains water
• Nozzle partially blocked
• Water filter blocked
• Hose kinked
• Pump/spray gun is leaking
• Trigger mechanism is broken
• Pump/hoses or accessories frozen
• No water supply
• Water filter blocked
• Nozzle blocked
Possible Solution
• Check to make sure the batteries have
sufficient power and are inserted well
• Check the hoses and connections are airtight
• Clean or replace valves/seals
• Please call the Snow Joe
service center at 1-866-SNOWJOE (1-866-766-9563)
for assistance
• Clean the nozzle
• Charge the batteries.
• Allow machine to run by holding the trigger until
regular working pressure resumes
• Check that the water supply corresponds to the
specifications required
• WARNING! Avoid using long, thin hoses
(minimum 1/2 in. diameter)
• Clean the nozzle
• Clean the filters
• Straighten out the hose to remove any kinks/blockages
• Please call Snow Joe
center at 1-866-SNOWJOE (1-866-766-9563) for
assistance
• Wait for pump/hoses or accessories to thaw
• Connect inlet water
• Clean the filters
• Clean the nozzle
19
+ Sun Joe customer
® ®
+ Sun Joe customer service
® ®