sunjoe 24V-X2-PW1200 Manuel De L'opérateur page 13

Fig. 20
7. Attach garden hose to water supply (Fig. 21).
m
WARNING!
Water that has flowed through back flow
preventers is considered to be non-potable.
m
WARNING!
The water supply must not exceed 0.7Mpa.
Fig. 21
Connect to water supply
Garden hose
8. If only using the base unit, turn the water supply tap
on completely.
9. Push the safety lock on the spray gun handle, then press
the trigger for a few seconds until the water flow is steady.
Operating the pressure washer in this manner will allow
air to escape and discharge residual pressure in the hose
(Fig. 22).
Fig. 22
Garden hose
Safety lock
Trigger
10. Keeping the trigger pressed, turn on the unit by pressing
the On/Off button on the control panel. Using the "Pressure
Select" feature, you can also use the pressure washer in a
lower setting by pressing the
button (Fig. 23).
Fig. 23
NOTE: This machine is equipped with 2 power/pressure levels.
When starting, the machine is set in default high power/high
pressure level. See table below for detailed specs.
Light
Power
indication
– On
High
– Off
– On
Low
– On
11. When re-starting the motor, always keep the trigger
pressed.
NOTE: The motor only runs when the trigger is operated
and shuts off when the trigger is released.
Control Panel (Fig. 24)
Fig. 24
On/Off button
Power indicator
Low power
mode indicator
Low power
setting button
13
button below the ON/Off
Control panel
Rated
Rated flow
pressure
0.65 GPM 800 PSI
0.77 GPM 650 PSI
Error indicator