Table Des Matières - Bosch MUZS2FWW Notice D'utilisation

Set up the base unit as described
1.
in the main operating instructions.
Press the release button and move
2.
the swivel arm down until it en-
gages in the vertical position.
→ Fig.
3
a The swivel arm is fixed in posi-
tion 3.
Rotate the base unit to the operat-
3.
ing position.
→ Fig.
4
Inserting the seal
Insert the seal into the housing
▶
and press in firmly.
→ Fig.
5
The recesses must match up ex-
actly.
Assembling the attachments
Note: To use the special accessory,
you need the parts of the meat min-
cer, except for the knife and perfor-
ated disc.
Assembling the meat mincer
Fit the worm gear into the housing
1.
with the agitator paddle at the
front.
→ Fig.
6
Fit the knife onto the worm gear
2.
with the square projection at the
front.
→ Fig.
7
Insert the required perforated disc
3.
into the housing.
→ Fig.
8
Observe the recess on the perfor-
ated disc.
Fit the threaded ring and tighten
4.
clockwise slightly.
→ Fig.
9
1
Special accessory
Assembling the juicer attachment
Follow the illustrated instructions.
→ Fig. -
10 14
Assembling the Viennese whirl
1
attachment
Follow the illustrated instructions.
→ Fig. -
15 18
Assembling the grater attachment
Follow the illustrated instructions.
→ Fig. -
19 22
Fitting the attachment
Open the locking lever.
1.
→ Fig.
23
Hold the prepared attachment hori-
2.
zontally and match up the ends of
the agitator paddle with the drive.
→ Fig.
24
Push the attachment fully onto the
3.
drive.
Rotate the attachment anticlock-
4.
wise as far as possible.
→ Fig.
25
Close the locking lever.
5.
→ Fig.
26
Tighten the threaded ring clock-
6.
wise.
Attach the filling tray.
7.
→ Fig.
27
Place a suitable container under
8.
the attachment.
→ Fig.
28
Basic operation
Basic operation
You can find out everything you need
Basic operation
to know about operating your ac-
cessory here.
Basic operation en
1
1
19