Intended Use Of The Equipment - Denios DT 1 / 60 Mode D'emploi

Masquer les pouces

Table des Matières

Les langues disponibles

Claims for defects and liability

DENIOS is not liable for claims for defects, damage or injury to persons or property caused by one or more of the

following:

Misuse



Incorrect assembly, commissioning, operation or maintenance



Non-observance of the notices in these operating instructions



Use of the product when defects or faults are present



Incorrectly conducted repair work



Vandalism



Catastrophe situations caused by the effect of foreign bodies and force majeure



Independent conversion of the product



Observe the following safety instructions for use in Ex zones:

During the handling, storage and dispensing of substances which can create an explosive atmosphere, the



requirements of ATEX Directive 1999/92/EC must be observed. Depending on each Ex zone, you must take

measures to prevent the ignition of an explosive atmosphere in each individual case.

Use suitable techniques to avoid sources of thermal ignition, for example friction, lightning, open flames,



open lights and smoking.

Avoid mechanically produced sparks by using suitable tooling, suitable transport and loading equipment.



Avoid exceeding the permitted electrical conductivity values which are set out in the standards. These



values can change depending on the depositing of hindering substances and also by chemical and

mechanical influences. In particular, dust, dirt, paint, acids and alkalis can reduce or completely prevent the

conduction of electrical/electrostatic energy to the floor.

Before every use of the drum dolly in an Ex zone check the castors for dirt and foreign bodies and clean



them if necessary.

Check the drum dolly for any corrosion damage. If corrosion damage is present the drum dolly must not be



used.

When using the drum dolly in an Ex zone, all objects which can come into contact with the drum dolly must



be electrically conductive:

2.1