Dmx Operation - Renkforce LV-PT12 Notice D'emploi

b) DMX Operation
Each DMX device in a DMX chain requires a so-called DMX starting address to be clearly identified by the
controller. This DMX starting address specifies the first DMX channel to which the effect light responds. The
remaining control channels come after this first DMX channel (DMX starting address).
The effect light requires 7 free DMX channels.
• Push the button MENU (5), until "d" shows in the display (4), followed by a number. The number is the DMX start
address.
• Select the desired starting address 001-512 with the UP (6) and DOWN (7) buttons.
• If you operate several effect lights in a DMX chain, you can also set the DMX start address as follows.
This ensures that every effect light is assigned its 7 DMX channels and that the DMX channel groups follow
in sequence.
Push the button MENU (5), until "IP" shows in the display (4), followed by a number. The digit is the number of the
effect light in the DMX chain.
"IP.01" assigns the 1st effect light DMX channels 1-7
"IP.02" assigns the 2nd effect light DMX channels 8-14 and so on.
Up to 73 effect lights can be encoded this way.
The following table provides information about the effects of the settings on the individual DMX channels.
DMX channel Value
1 000-010
011-050
051-100
101-150
151-200
201-255
2 000-255
3 000-255
4 000-255
5 000-255
6 000-255
7 000-255
28
Function
Colour setting via channel 4-7
static colours
Colour change function
Fade function
Sound-to-light function
Strobe effect
Colour selection
Speed
Overall brightness dark >> bright only active when channel 1= 000-010
Brightness red dark >> bright
Brightness green dark >> bright
Brightness blue dark >> bright
Comment
Channel 2 and 3 without function
Colour selection with channel 2
Channel 3-7 without function
Speed via channel 3
Channel 2 and 4-7 without function
Colour selection with channel 2
Speed via channel 3
Channel 4-7 without function
Colour selection with channel 2
Channel 3-7 without function
Colour selection with channel 2
Speed via channel 3
Channel 4-7 without function
only active when channel 1= 000-010
only active when channel 1= 000-010
only active when channel 1= 000-010