Bartscher A300.068 Mode D'emploi page 33

Sending data / printing function
•
If the electronic digital scale is to be integrated with the computer system, the
RS 232 connector allows for data transfer from the weighing operation.
•
Press and hold
weighing operation are sent from the CPU to the connected computer or printer.
Counting mode (number of pieces)
•
That function of the digital scale allows for determination of number of pieces in one
sample. The number of pieces is determined upon the basis of known weight of a
single piece.
•
Remove all objects from the weighing surface and press
•
press until the device switches to "pcs" mode and the display shows
"ADD10".
•
By pressing
•
Place the number of pieces corresponding to the setting (5, 10, 20, 50) on the
weighing surface.
Caution: the weight of each piece must be higher from the minimum allowable partial
weight, otherwise the display shows symbol "no".
The pieces weight must be identical.
•
Press in order to calculate the unitary weight and save it in the memory.
•
Remove the weighed objects from the weighing surface. The digital scale is now set for
calculating the objects of the same unitary weight.
•
Place the objects to be counted on the weighing surface. The digital display shows
number of pieces of a given object.
•
In order to count another number of a given objects press
operation is to be terminated, press
saves the last value used for counting.
for 2 seconds, the acoustic signal is emitted and data from the
it is possible to set the number of pieces (20, 50, 5).
to stop the counting mode and the scale
to set the device to "0".
If the counting
.
- 29 -