Bartscher A300.068 Mode D'emploi page 30

Power on/off
•
When the device is to be supplied from the adapter, connect the adapter to the
device by putting the plug in appropriate socket on the left side of the remote
display, then put the network plug in the single wall socket with earthing.
ATTENTION!
Only use the original adapter for the scale.
Other adapters may lead to permanent electric damage.
•
The device may also be supplied from the batteries. Open the battery compartment
on the right side of the display and install 4 alkaline batteries AAA, paying attention to
polarity. Close the battery compartment.
•
When there are no objects on the weighing surface, press ON/OFF
display shows all symbols for a few seconds, then the maximum load and scaling.
•
When the display shows "0", weighing of objects may begin.
•
To turn off the scale press ON/OFF
•
When the digital scale is not used, remove the network plug from the wall socket. In
case of longer inactivity remove the batteries from the device.
Weighing
•
Press ON/OFF
When the device is turned on, all values appear on the display for a few seconds
and then the display shows "0". Weighing may begin.
•
Selecting the weighing unit using the button
Press to select "kg" or "lb". The weighing unit appears after selection next to the
displayed weight. When the indication stops blinking (which means that the data are
stable), the weighed value may be read.
•
Weighing without a container:
Check whether "0" is displayed. If not, press
to be weighed on the weighing surface. Once the value is stable, the stability
indicator "►" appears on the display.
- 26 -
to turn the scale on.
again .
to display "0". Place the objects
. The digital