Bartscher A300.068 Mode D'emploi page 31

•
Weighing with a container:
Place the empty container on the weighing surface. Wait until the stability indicator "►"
appears and press
value is stable, the stability indicator "►" appears on the display.
Calibration methods
Arbitrary single-point calibration
a) Turn on the device, press and hold
b) Press or
"CAL".
c) Press to make sure that the calibration mode is active.
d) The digital display shows "Load" and "0.0kg" alternately.
e) Make sure that there are no objects on the weighing surface. Press
scale calibration for "0.0kg". During the calibration for "0.0kg" the symbol "0.0kg"
flashes on the display. Assure peace and stability of the weighing surface, as well as
lack of influence of other factors which might disturb weighing. When the load is
maintained in a stable way for longer than 2 seconds, the scale automatically finishes
calibration for "0.0kg" and switches to the next calibration step. Otherwise the symbol
"0.0kg" still flashes on the display until the load is stabilized.
f) Assuming that the next calibration step is "xx.xkg", the digital display shows
"Load" and "xx.xkg" alternately, which means that the load of "xx.xkg" should be
placed on the weighing surface. When that load needs to be modified, press
to enter the modification menu. Then press
position. Press
make sure that the modification has been made.
g) Make sure that the load on the weighing surface is "xx.xkg" and press
confirm the calibration of "xx.xkg". During the calibration for "xx.xkg" the symbol
"xx.xkg" flashes on the display. Assure peace and stability of the weighing surface,
as well as lack of influence of other factors which might disturb weighing. When the
load is maintained in a stable way for longer than 2 seconds, the scale automatically
finishes calibration for "xx.xkg" and saves the calibration parameters in the
memory. Otherwise the symbol "xx.xkg" still flashes on the display until the load is
stabilized.
. Place the objects to be weighed in the container. Once the
to switch to the calibration mode. The digital display shows
to increase the flashing position by „plus 1" and press
until the display shows "------".
to modify the flashing
to confirm the
or
to
to
- 27 -