Publicité
Les langues disponibles
Les langues disponibles
Before you fit the grass bag you must ensure that the motor is switched off and
the blade is not rotating. Lift the chute flap (7) with one hand. With the other hand,
hold the grass bag by the handle and hook it in from above.
Secure the cable using the supplied cable securing clips.
Adjusting the cutting height (Fig. 7)
6
5
4
3
2
1
fig. 7
Important. Adjust the cutting height only when the motor is switched off and the
safety plug has been pulled. Before you begin to mow, check to ensure that the
blade is not blunt and that none of the fasteners are damaged. To prevent any
imbalance, replace blunt and/or damaged blades.
To carry out this check, first switch off the motor and pull out the safety plug.
To do so, push the lever of the cutting height adjustment (8) inwards, select the
required cutting height by moving the lever to the left or right and pull back the
lever to one of the six graduations (Figure 7/Item 1-6). Make sure that the lever
engages properly.
Position 1
Cutting height: 25 mm
Position 2
Cutting height: 35 mm
Position 3
Cutting height: 45 mm
Position 4
Cutting height: 55 mm
Position 5
Cutting height: 65 mm
Position 6
Cutting height: 75 mm
Publicité
