• 28 •
10- Remove the dispensing spout from the
fitting.
11- Remove the fitting from the rubber
tube.
12- Wash the carafe lid with lukewarm run-
ning water.
Do not place the carafe lid in the
dishwasher to prevent the part
from discolouring.
13- Open the dispensing spout lid.
14- Remove the lower part of the dispens-
ing spout.
15- Wash all the components with luke-
warm running water. The internal parts
of the frothing system are dishwasher
safe. When all components have been
washed, reassemble them following the
same procedure, but in reverse order.
Monthly cleaning of the milk carafe
In order to keep the entire circuit free of
milk residue and to guarantee the best and
long-lasting performance of the carafe, we
advise performing a monthly cleaning cy-
cle with ''Saeco Milk Circuit Cleaner'' , which
is sold separately.
Before starting the cleaning cycle, check that the
On/Off button
stantly lit and that there is enough water in the tank.
1- Remove the milk carafe lid and wash both components in luke-
warm running water.
2- Fill the carafe up to the MAX level with fresh, lukewarm water.
3- Pour the detergent product into the milk carafe and let it dis-
solve fully.
4- Replace the lid on the carafe, insert it into the machine and
place a container under the milk dispensing spout.
Warning! Dispensing may be preceded by small jets
of hot water: danger of scalding! If the carafe is ab-
sent, products requiring milk should not be selected.
Never drink the solution dispensed during this
procedure.
5- With the machine turned on, press the Frothed milk button .
Wait until it has finished dispensing.
6- Empty the container and place it back under the milk dispensing
spout.
7- Repeat steps 5 to 6 until the milk carafe is empty, then proceed to
step 8.
8- Remove the carafe from the machine and wash thoroughly with
fresh water.
9- Fill the milk carafe with fresh drinking water up to the MAX level
and then place it back in the machine.
10- With the machine turned on, press the Frothed milk button .
Wait until it has finished dispensing.
11- Press the rinse button
dispensing.
12- Empty the container and place it back under the milk dispensing
spout.
13- Repeat steps 10 to 12 until the milk carafe is empty, then proceed
to step 14.
14- Remove and wash the milk carafe as described in the section
"Weekly cleaning of the milk carafe".
and product buttons are con-
(orange). Wait until it has finished