Installation Instructions - Electrolux EHE60000X Notice D'utilisation

12 electrolux installation instructions

Installation Instructions

Safety instructions
Warning! This must be read!
The laws, ordinances, directives and
standards in force in the country of use
are to be followed (safety regulations,
proper recycling in accordance with the
regulations, etc.)
Installation may only be carried out by a
qualified electrician.
The minimum distances to other appli-
ances and units are to be observed.
Drawers may only be installed under
the appliance with a protective floor.
The cut surfaces of the worktop are to
be protected against moisture using a
suitable sealant.
The sealant seals the appliance to the
work top with no gap.
Do not use silicon sealant between the
appliance and the work top.
Avoid installing the appliance next to
doors and under windows. Otherwise
hot cookware may be knocked off the
rings when doors and windows are
opened.
z
Risk of injury from electrical
current.
The combination appliance is live.
• Observe electrical safety rules.
• Ensure anti-shock protection
through correct installation by a
qualified electrician.
• Rated voltage of the combined appli-
ances must match.
z
Risk of injury from electrical
current.
Loose and inappropriate plug and
socket connections can lead to
overheating of the plug.
• Fit plug and socket connections to-
gether properly.
A device must be provided in the electri-
cal installation which allows the appli-
ance to be disconnected from the mains
at all poles with a contact opening width
of at least 3 mm.
Suitable isolation devices include line
protecting cut-outs, fuses (screw type
fuses are to be removed from the hold-
er), earth leakage trips and contactors.
Sticking on the seal
• Clean the worktop around the cut-
out area.
• Attach the supplied one-sided adhe-
sive liner tape around the cut-out on
the top surface of the worktop. The
joining point of the two ends should
be in the middle of one of the sides.
After cutting the correct length (allow
a few millimetres) simply press the
two ends against each other.