Franke FSDR 400 XS E Manuel D'utilisation page 41

[--] is displayed
on the fridge set
value.
If your fridge is not working properly, it may be a minor problem, therefore check the following,
before calling an electrician to save time and money.
What to do if your appliance does not operate;
Check that;
• There is no power,
• The general switch in your home is disconnected ,
• The socket is not sufficient. To check this, plug in another appliance that you know which
is working into the same socket.
What to do if your appliance performs poorly;
Check that;
• You have not overloaded the appliance ,
• The fridge temperature set to 2.
• The door is closed perfectly ,
• There is no dust on the condenser ,
• There is enough place at the rear and side walls.
If your fridge is operating too loudly;
Normal Noises
Short cracking: Heard when the thermostat switches the compressor on/off.
Compressor noise: Normal motor noise. This noise means that the compressor operates
normally Compressor may cause more noise for a short time when it is activated.
Bubbling noise and splash: This noise is caused by the flow of the refrigerant in the tubes
of the system.
Water flow noise: Normal flow noise of water flowing to the evaporation container during
defrosting. This noise can be heard during defrosting.
Air Blow Noise: Normal fan noise. This noise can be heard in fridges during normal
operation of the system due to the circulation of air.
If the edges of fridge cabinet that the door joint contact are warm;
Especially in summer (hot weather), the surfaces that the joint contact may
get warmer during the operation of the compressor, this is normal.
Fridge switches to the
Low voltage standby mode when the
warning voltage supply falls below
170 Volts.
EN - 41 -
This feature prevents
the compressor from
getting damaged due
to low voltage. Fridge
will start operating
automatically when the
voltage restores to the
required level.