Commissioning; Disposal - resideo Braukmann DDS76 Instructions D'installation

4

Commissioning

4.1 Setting
1. The differential pressure at which a reverse rinsing
cycle should be started should be set by turning the
adjuster knob until the desired value on scale aligns
with the markings
The value should be set to correspondance to the
degree of contamination at which reverse rinsing
should occur.
The higher the set value, the greater the degree of
contamination.
If the value is set too low, this can lead to over frequent
reverse rinsing and consequent loss of water.
The setting of the automatic reverse rinse actuator
must not be changed. The time interval setting
continues to operate..
MU1H-1118GE23 R0220
GB
5

Disposal

Observe the local requirements regarding correct waste
recycling/disposal!
3