Publicité
Les langues disponibles
Les langues disponibles
Sanding
Prior to commencement of work one
should perform test sanding on an un-
necessary element (made of the same
material or with the same coating as the
machined component) to ensure that the coarseness
and type of sanding sheet, as well as the oscillation
frequency of the sanding plate 5 have been selected
properly.
• Ensure that the element to be sanded is firmly se-
cured�
• Turn on the power tool earlier, before sanding plate 5
touches the element to be sanded and allow the engine
of the power tool to reach maximum oscillation rate�
• Apply sanding plate 5 to the surface of the machined
element and move the power tool in circular or recip-
rocating motion�
• Perform sanding with the whole surface of sanding
plate 5�
• Do not press the power tool excessively, since this
will not provide better results, but will only overload the
engine of the power tool and will result in higher sand-
ing sheet consumption�
• Do not stop the power tool in a single spot this will
result in a depression in the stoppage place�
• At relevant time, replace the used or dust-blocked
sanding sheets�
• Use sanding sheets of varying coarseness com-
mence the work with a coarse sheet and gradually pro-
ceed to finer sheets. It will make the work faster and
will result in smoother surface�
• Do not reuse sanding sheets that were previously
used for sanding metal for any other materials�
Power tool maintenance /
preventive measures
Before carrying out any works on the power tool it
must be disconnected from the mains.
The manufacturer reserves the possibility to introduce changes.
Cleaning of the power tool
An indispensable condition for a safe long-term exploi-
tation of the power tool is to keep it clean� Regularly
flush the power tool with compressed air thought the
ventilation slots 2�
After-sales service and application service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts� Information about service centers,
parts diagrams and information about spare parts can
also be found under: www.dwt-pt.com�
•
Categorically not to drop any mechanical impact on
the packaging during transport�
• When unloading / loading is not allowed to use any
kind of technology that works on the principle of clamp-
ing packaging�
Recycle raw materials instead of dispos-
ing as waste.
Power tool, accessories and packaging
should be sorted for environment-friendly
recycling�
The plastic components are labelled for categorized
recycling�
These instructions are printed on recycled paper man-
ufactured without chlorine�
English
20
Transportation
of the power tools
Environmental
protection
Publicité
