DWT HB02-82 B Notice Originale page 20

Symbol
Wear ear protectors�
Wear a dust mask�
Disconnect the power tool
from the mains before instal-
lation or adjustment�
Movement direction�
Rotation direction�
Locked�
Unlocked�
Prohibited�
Double insulation / protec-
tion class�
Attention� Important�
A sign certifying that the
product complies with es-
sential requirements of the
EU directives and harmo-
nized EU standards�
During operation, remove
the accumulated dust�
Caution! Possible injury from
sharp edges of a cutting ac-
cessory�
Do not dispose of the power
tool in a domestic waste
container�
Meaning
English
20
power tool designation
The power planer is designed for planing, edge cutting,
grooving of wood and wood materials� The power
planer is designed for use by right-handers only�
There is a possibility of a stationary installation of the
tool by use of some special accessories�
Power tool
components
1 Front base plate
2 V-groove
3 Planing depth setting scale
4 Additional handle with regulator for planing depth
adjustment
5 On / off switch
6 Lock-off button
7 Protective casing
8 Back base plate
9 Ventilation slots
10 Nozzle
11 Vertical stop *
12 Side stop (assembly) *
13 Wing screw *
14 Blade sharpening device (assembly) *
15 Blade alignment fixture (assembly) *
16 Box wrench *
17 Dust bag *
18 Bracket *
19 Thrust plate *
20 Fastening nut *
21 Clamping bolt *
22 Cover
23 Adjusting plate for resharpenable blade
24 Screw
25 Resharpenable blades *
26 Drum for resharpenable blades
27 Clamping bolt of blade sharpening device *
28 Template *
29 Plate *
30 Washer *
31 Winged nut *
32 Driving belt *
33 Housing screw
* Optional extra
Not all of the accessories illustrated or described
are included as standard delivery.
Installation and regulation
of power tool elements
Before carrying out any works on the power tool it
must be disconnected from the mains.
Do not draw up the fastening elements
too tight to avoid damaging the thread.
Installation / dismantling of the side stop (see
fig. 1)
• Assembly side stop 12 as it is shown in fig. 1.
• Install the side stop 12 using the wing screw 13 (see
fig. 1).
• Disassembly operations do in reverse sequence�
DWT