Panasonic AW-HS50E Mode D'emploi page 9

Characteristics
Straightforward and flexible operability
  The control panel layout includes a row of five
crosspoint buttons for the A bus and another row of
five crosspoint buttons for the B bus. Using these
buttons together with the SHIFT button enables a
total of ten images to be switched. Cut switches are
also made possible by the CUT button.
  Separate buttons enable the PinP, KEY and FTB
functions to be turned ON or OFF in a single-step
action.
  The slide lever is not only used to initiate
background transition operations but it can also
be allocated to execute PinP and KEY fade in/out
operations.
  Two USER buttons located on control panel.
Using these buttons together with the SHIFT button
allows a total of four user settings (USER1 to
USER4) to be allocated.
PinP settings or WIPE pattern settings can be
allocated to the USER buttons.
On-screen display (OSD)
  The setting menus can be displayed on an external
monitor from the SDI OUT 2 and DVI OUT output
connectors.
(These menus cannot be displayed using the
SDI OUT 1 output connector.)
Function for linkup with a remote camera
controller using IP connection
  The unit can be connected to a Panasonic remote
camera controller using a network.
By linking it with a remote camera controller, it is
possible to put together a highly efficient operating
environment.
Supported remote camera controller:
AW-RP50
Only one switcher (the unit) can be linked with a
remote camera controller.
[Display of camera information]
The camera setting information (iris, gain and so
on) obtained by the AW-RP50 can be displayed
in the AUX output or on the split screens of multi
view display.
[Transmission of tally information]
The unit's ON AIR tally information can be sent
to the AW-RP50.
[Switching of materials]
The bus materials of the switcher (the unit) can
be selected from the AW-RP50.
They can be switched in tandem with the
selection of the camera using the AW-RP50.
(Control buses supported: AUX, PVW, PinP,
KEY-F)
[Focus assist function]
By operating the buttons on the AW-RP50, it
is possible to switch to the multi view display
screen from the full screen display of the camera
images.
(Control bus supported: AUX)
[ Parameter operation using PAN/TILT lever and
ZOOM button]
The PAN/TILT lever and ZOOM button on the
AW-RP50 can be used to change the parameters
of the switcher (the unit).
8 (E)