Panasonic AW-HS50E Mode D'emploi page 18

1. Parts and their functions
 DVI OUT connector [DVI OUT]
This is the DVI-D signal output connector.
Signals with the following resolution can be output
from this connector by menu operations.
Digital RGB (vertical frequency: 60 Hz):
XGA (1024  768), WXGA (1280  768),
SXGA (1280  1024), WSXGA+ (1680  1050),
UXGA (1600  1200), WUXGA (1920  1200)
Digital RGB:
1920  1080/50p, 1920  1080/59.94p
Furthermore, the following signals can be assigned
by menu operations.
PGM, PVW, CLN, AUX, MV, KEYOUT
The connector supports the high-resolution multi
view mode so that images can be output at a high
resolution when SD has been selected as the
system format.
 Analogue signals cannot be output from this
connector.
A DVI-I cable cannot be used.
 When the high-resolution multi view mode
has been enabled, MV signals are assigned
to the DVI OUT connector, and they cannot
be assigned to the SDI OUT 1 connector or
SDI OUT 2 connector.
 LAN connector [LAN] (RJ-45)
(10BASE-T/100BASE-TX)
The remote camera, remote camera controller and
host computer supporting IP connections to this
LAN connector are connected using LAN cables.
When a device is connected directly to the unit, use
a crossover cable (category 5 or above).
When a device is to be connected to the unit
through a hub (switching hub), for instance, use a
straight cable (category 5 or above).
 TALLY/GPI connector [TALLY/GPI]
(D-sub 15-pin, female, inch thread)
This connector features five contact input ports
for controlling the unit from an external device and
seven open collector output ports for outputting the
tally information and alarm information from the unit.
 Cooling fan
 DC IN connector [12V
The AC adapter provided with the unit is connected
to this connector.
 Ground terminal [SIGNAL GND]
Connect this to the system's ground.
 SERVICE switch [SV/NM]
This switch is used for maintenance purposes.
For normal operations, select the "NM" position.
 Wire fastening fitting
An anti-theft wire available on the market can be
fastened to this fitting to prevent theft.
17 (E)
IN] (DC 12 V, 2.0 A)