Precision TA500 Manuel D'utilisation page 8

7. Place the 1/2" Nylon Washer onto the threaded stud on the Lever Link, insert the stud into one of the holes
of the Linkage Bar, and secure with a 1/2" Nylock Nut (Tighten all the way until snug then back off 1/2 a turn).
Insert 1/2" x 1-1/2" Hex Head Bolt into the Axle Link, place a 1/2" Nylon Washer on to the bolt, insert the bolt into
the rear hole of the Linkage Bar, secure a 1/2" Nylock Nut. Insert the 1/2" x 1-3/4" Shoulder Bolt into a 1/2" Flat
Washer, the Compression Spring, another 1/2" Flat Washer. Insert the bolt into the larger center hole of the Lever
Link, followed by a 1/2" Flat Washer. Insert the bolt into the one hole on the vertical portion of the Handle Brace,
and secure with a 3/8" Jam Nut. See Figure 7.
Compression Spring
Compression Spring
1/2" x 1-3/4"
1/2" x 1-3/4"
Shoulder Bolt
Shoulder Bolt
1/2" Nylock
1/2" Nylock
Nut
Nut
1/2" Flat Washer
1/2" Flat Washer
Figure 7
Figure 7
Lever Link
Lever Link
Linkage Bar
Linkage Bar
8
Handle Brace
Handle Brace
3/8" Flat Washer
3/8" Flat Washer
3/8" Jam Nut
3/8" Jam Nut
1/2" x 1-1/4"
1/2" x 1-1/4"
Hex Head Bolt
Hex Head Bolt
1/2" Flat Washer
1/2" Flat Washer
1/2" Nylon Washer
1/2" Nylon Washer