Precision TA500 Manuel D'utilisation page 5

2. Align the three rear holes in the Tow Bar with the corresponding hole in the Base Plate. Insert a 5/16" x 3/4"
Hex Head Bolt into one of the holes in the Base Plate then through the corresponding hole in the Tow Bar. Insert
a 5/16" Flat Washer onto the bolt followed by a 5/16" Lock Washer, then secure with a 5/16" Hex Head Nut.
Repeat process on the remaining two holes. See Figure 2.
Tow Bar
Tow Bar
5/16" x 3/4" Hex Head Bolt
Figure 2
Figure 2
3. Insert a 5/16" x 1" Hex Head Bolt into one of the nine remaining holes in the Base Plate, place a 5/16" Fender
Washer onto the bolt followed a 5/16" Flat Washer and a 5/16" Lock Washer. Loosely attach a 5/16" Hex Head
Nut. Repeat process on the remaining eight holes. Slide a Tine between a Fender Washer and the Base Plate,
secure Hex Head Nut, repeat on the remaining eight Tines. See Figure 3.
5/16" Flat Washer
5/16" Flat Washer
5/16" Fender Washer
5/16" Fender Washer
5/16" x 1" Hex
5/16" x 1" Hex
Figure 3
Figure 3
5/16" x 3/4" Hex Head Bolt
Head Bolt
Head Bolt
5/16" Hex Head Nut
5/16" Hex Head Nut
5/16" Lock Washer
5/16" Lock Washer
5/16" Flat Washer
5/16" Flat Washer
5/16" Hex Head Nut
5/16" Hex Head Nut
5/16" Lock Washer
5/16" Lock Washer
5
Base Plate
Base Plate
Tine
Tine
Base Plate
Base Plate