Precision TA500 Manuel D'utilisation page 7

6. Align the two holes of the Tow Bar and Handle Brace as shown. Insert a 5/16" x 1" Hex Head Bolt into one of
the holes in the Handle Stop and then through the corresponding hole in the Tow Bar, place a 5/16" Flat Washer
on to the bolt, and secure with a 5/16" Nylock Nut. Repeat process on the next hole. Insert a 5/16" x 3/4" Hex
Head Bolt into one of the two smaller holes on the Clevis Plate and then into the corresponding hole in the Tow
Bar, place a 5/16" Lock Washer onto the bolt and secure with a 5/16" Hex Head Nut. Repeat process on the next
hole. Insert the Clevis Pin through the larger front hole of the Clevis Plate and through the hole in the Tow Bar
and secure with the Hitch Pin Clip. See Figure 6.
5/16" x 1" Hex Head Bolt
5/16" x 1" Hex Head Bolt
Handle Brace
Handle Brace
Figure 6
Figure 6
5/16" x 3/4" Hex
5/16" x 3/4" Hex
Head Bolt
5/16" Flat Washer
5/16" Flat Washer
5/16" Lock Washer 5/16" Lock Washer
5/16" Nylock
5/16" Nylock
Nut
Nut
Hitch Pin Clip
7
Clevis Pin
Clevis Pin
Head Bolt
5/16" Hex
5/16" Hex
Head Nut
Head Nut
Hitch Pin Clip
Clevis Plate
Clevis Plate
Tow Bar
Tow Bar