DWT OF-1050 NV Notice Originale page 28

Note: the
not be less than 8 mm. Additionally,
when making a template, please note
that the router bit follows the template
contour with a certain offset (distance "b" in
figure 19).
Power tool maintenance /
preventive measures
Before carrying out any works on the power tool it
must be disconnected from the mains.
Cleaning the dust
fig. 20-21)
• Unscrew screws 35 and remove cover 36 as shown
in figures 20-21.
• Clean the groove with a soft brush�
• Install cover 36 and screw in screws 35�
Cleaning of the power tool
An indispensable condition for a safe long-term
exploitation of the power tool is to keep it clean�
Regularly flush the power tool with compressed air
thought the ventilation slots 6�
The manufacturer reserves the possibility to introduce changes.
template thickness
extraction groove
must After-sales service and application service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts� Information about service centers,
parts diagrams and information about spare parts can
also be found under: www.dwt-pt.com�
• Categorically not to drop any mechanical impact on
the packaging during transport�
• When unloading / loading is not allowed to use
any kind of technology that works on the principle of
(see
clamping packaging�
Recycle raw materials instead of dispos-
ing as waste.
Power tool, accessories and packaging should
be sorted for environment-friendly recycling�
The plastic components are labelled for categorized
recycling�
These instructions are printed on recycled paper
manufactured without chlorine�
English
28
Transportation
of the power tools
Environmental
protection