DWT OF-1050 NV Notice Originale page 25

Symbol
Read all safety regulations
and instructions�
Wear safety goggles�
Wear ear protectors�
Wear a dust mask�
Disconnect the power tool
from the mains before instal-
lation or adjustment�
Movement direction�
Rotation direction�
Locked�
Unlocked�
Double insulation / protec-
tion class�
Attention� Important�
Useful information�
Wear protective gloves�
During operation, remove
the accumulated dust�
Do not dispose of the power
tool in a domestic waste
container�
Meaning
English
25
power tool designation
Power tools are designed for slot and hole milling as
well as for treating the edges of workpieces made from
wood-based materials, plastic, etc�
The use of special accessories also makes it possible
to perform the copy milling, to machine edges of
workpieces with a curved profile, to mill along the
workpiece edge as well as to mill circular slots (certain
accessories that enable the above listed works to be
performed are not included in the delivery set)�
Power tool
components
1 Lock-on button
2 On / off switch
3 Handle
4 Base plate
5 Wing screw
6 Ventilation slots
7 Controller for the fine adjustment of the milling
depth
8 Locking lever
9 Dust removal cover *
10 Dust removal pipe
11 Spindle lock
12 Collet clamp nut
13 Speed selector thumbwheel
14 Milling depth gauge
15 Indicator
16 Flywheel
17 Locking screw
18 Locknut
19 Adjusting screw
20 Stepped stop
21 Bush *
22 Dust extractor connecting adaptor *
23 Copy ring fixing screws *
24 Guide bushing *
25 Wrench *
26 Parallel guide (assembly) *
27 Scale
28 Collet
29 Spindle
30 Locking ring
31 Fixing screws of the dust removal cover *
32 Parallel guide fixing elements *
33 Guide *
34 Parallel guide adjusting screw *
35 Fixing screws of the base plate cover
36 Base plate cover
* Optional extra
Not all of the accessories illustrated or described
are included as standard delivery.
Installation and regulation
of power tool elements
Before carrying out any works on the power tool it
must be disconnected from the mains.
Mounting / dismounting / setting-up of
some elements is the same for all power
tool models, in this case specific models
are not indicated in the illustration.
DWT