Altrad EASY SCREED PRO Manuel De L'opérateur page 12

GB
If the Easy Screed Pro is not operating properly then one or more of the following problems could be the cause.
Problem
The Easy Screed Pro,
screeder, vibrates too
much and does not travel
smoothly across the form
work.
smoothed in the proper way. the leading edge.
engine fails to start or runs The starting procedure was not executed
irregularly.
GB
date of purchase. The Belle Group warranty is against defects in design, materials and workmanship.
The following are not covered under the Belle Group warranty:
operation or user maintenance instruction.
Screed Pro.
claim, on any machine.
The following components are not covered by warranty:
ages, losses or expenses in connection with or by reason of or the inability to use the machine for any purpose.
Warranty Claims
For warranty claims:
Belle Group Warranty Department,
Sheen, Nr. Buxton
Derbyshire,
England
Trouble Shooting Guide
Cause
The vibrator vibrates too much for the
unstable on the form work and cannot travel
or function in the proper way.
in the proper way.
A failure in the engine.
Remedy
Refer to the Opertion section of this manual for instructions
evenly spread out along the front of the leading beam.
Read the operation instructions of the gasoline engine
carefully and repeat the starting procedure.
Contact Agent or Belle Group.
Warranty
12