Altrad EASY SCREED PRO Manuel De L'opérateur page 10

GB
WARNING
How to assemble the Easy Screed Pro.
form screeder or as a free screeder.
CAUTION
Operation and use of the Easy Screed Pro.
freshly poured concrete surface.
Before starting the petrol engine read the enclosed operation instructions carefully. Make sure before
CAUTION
speed depends on the consistency of the
concrete.
4. If the Easy Screed Pro vibrates to strong the
centrifugal force needs to be reduced. This
protection cover and adjust the eccentrical
A well adjusted screeder will create a level,
smooth and shining surface.
Pro from the concrete and switch off the petrol
engine.
to the instructions described in the Maintenance
section of this manual. Place the Easy Screed
Pro on a dry, clean and stable surface.
7. If you do not expect to use the engine for a long period of time, drain the fuel tank and let the engine run at idle speed until the fuel
in the carburettor is used and the engine stops.
Please observe the following instructions:
Screed Pro backwards.
concrete, move the Easy ScreedPro faster across the surface of the concrete.
How to adjust the centrifugal force:
NOTE:
Operating Instructions
Before you operate or carry out any maintenance on this machine YOU MUST READ and STUDY
this manual.
5
ON-OFF switch is in the ON position.
10
1
2
3
4
6