Tanita WB-8000RW Manuel D'utilisation page 4

d
d
<LED: Blinking Green (4 Second Intervals)>
d
d
<LED: Blinking Green (1 Second Intervals)>
Measurement Ended
d
6
5) Carefully step off WB-8000RW after measurement is
complete.
Note: •If you do not step off the scale within 30 seconds of
weighing, the WB-8000RW LED will be lit red and
emit two short beeps to remind you to step off the
scale.
When data output ends, the WB-8000RW LED will turn off,
and when you step off the WB-8000RW, it will switch to
standby mode (the LED will blink green in 4 second
intervals).
6) When the D-8000 display disappears, the scale can be used
for weighing again.
The value shown on the D-8000 will disappear, and after
switching to standby display, the unit will beep, and "-----"
will be shown on the display.
When the WB-8000RW starts up, beeps, and switches to
measurement mode (the LED will blink green in 1 second
intervals), please step onto the WB-8000RW.
Note: •If no measurement signal is received by the D-8000
from the WB-8000RW for a certain amount of time, the
Pi
D-8000 display value will disappear. When this
happens, the WB-8000RW will switch to standby mode
(the LED will blink green in 4 second intervals).
* To end measurement, press the D 8000 OFF key to turn
off the display. Switch the WB 8000RW mode selection
switch to the OFF position.
2. BMI mode
1) After step 3 "Press
LCD will display "-----". Press
d
The bottom half of the LCD will blink "170" (when the unit is set to "kg").
d
d
Press
Note: •When the weight display unit is set to "pounds", enter your height in inches.
d
2) Once you have finished entering your height, press
d
3) Step onto the WB-8000RW.
Note: •Enter your height within 30 seconds of the D-8000 displaying "-----".
4) After weighing, the D-8000 will display your weight and BMI.
3. Changing Units
You can change units by pressing the kg/lb key when the D-8000 displays "-----".
Note: •This function may not be available for all models.
d
4. Output Function
The WB-8000RW's output function is controlled by the mode selection switch's position.
LED: Green
LED: Blue
on the D-8000" of the "Standard Weighing Procedures", the top half of the
.
to enter your height in cm.
.
• When the WB-8000RW's mode selection switch is set to ON, both
wireless and USB output can be used. USB transmission will be set to
output-only, and when the display is set your weight and BMI will be
automatically output. The LED will be green.
• When the WB-8000RW's mode selection switch is set to USB ONLY, only
USB output can be used. USB transmission will be possible in both
directions (input and output). The LED will be blue.
7