Operation Hints; Misting Hints; Residual Spray Medium - Solo Master 452 Instructions D'emploi

13. Operation hints

13.1 Misting Hints

Open liquid tap: Lever in horizontal position  ON
Shut liquid tap: Lever in vertical position  OFF
The liquid output volume is adjusted by turning the
dosage sleeve to different positions.
When spraying predominantly upwards (tall trees)
we recommend using the liquid pump offered as
an accessory (part no.: 49117)
Misting Output Guide
Dosage A
sleeve
l/min
Position 1 0.60
Position 2 1.15
Position 3 2.25
Position 4 3.00
With wide-range nozzle (7), wide-angle grille (7a);
Note: The liquid pump attachment comprises a
special metering body, which should be installed
when using a liquid pump.
Please note: When using a liquid pump,
ensure that the tank contains sufficient
liquid. The liquid pump can sustain severe
damage, if it is permitted to run dry. When
using the equipment as a mister and as blower,
remove the pump for that reason.
13.2 Spraying
 When applying spraying agent, ensure by using
appropriate measures and procedures that the
unintended release of agent to other areas is
minimized and the drift to the surrounding areas
is prevented.
 Always proceed with the greatest care when
spraying.
 Never use the device under windy conditions or
if it is raining, as this would risk widespread
drifting of the spraying agent.
 Check the wind direction before starting work
and select the spraying direction downwind of
the user.
B A B
l/min l/min l/min
0.15 0.55 0.50
0.25 1.20 1.20
0.40 2.30 2.10
0.45 3.05 3.00
 It is best to perform spraying work in the morning
or evening, as it tends to be less windy then.
 Ensure that you only wet what is in fact intended
to be covered with spraying agents.
 Never spray the agent towards persons,
animals, open windows or doors, cars or
anything else that could be damaged by the
spraying agent.
Spraying:
Approach the target object with the engine at idling
speed. Accelerate to full engine speed, then open
formula on-off tap.
Wide-range nozzle (7):
Fig. 6
When spraying plants and trees we recommend
fixing the wide-range nozzle (7) onto the red
standard nozzle (4). This ensures that a large area
can be sprayed at one time. Push the wide-range
nozzle onto the standard nozzle, until the bead
engages.
In narrow spaces and for aftercare, we recommend
placing the wide-angle grille (7a) onto the wide-
range nozzle. This ensures that the spray velocity
is reduced and the spray is applied more
widespread, to prevent damage to leaves.

13.3 Residual spray medium

Switch off the appliance as soon as no further
liquid is expelled, when the metering body is
correctly positioned for spraying, or air bubbles are
visible inside the lance supply hose.
The tank will then contain less than 100 ml residual
medium.
If you don't want to refill the tank with spray
medium and you want to terminate spraying, dilute
the residual medium with 2 l of water. Dispose of
this solution on the treated area.
Operation hints
ENGLISH 11