Active Components Of The Operating Handle - Solo Master 452 Instructions D'emploi

7.1 Active components of the operating handle

Fig. 2
Completely assembly the mistblower before its first use:
Fig. 3
Assembly of misting equipment
Attach the blower elbow (22) to the blower housing and secure with both screws (A+B). Ensure the elbow
can swivel easily. Push pleated hose (C) onto blower elbow (22) and secure with clamp (D).
Assembly of handle, spray tube and spray nozzle
Push handle (E) onto spray tube (14)(start from the front) and fix in the required position. A guide (F) on
the spray tube will ensure vertical positioning. The adjustment scope is approx. 50mm depending on the
arm length of the operator.
Push the spray tube with twist coupling (G) into the pleated hose (C) until locked. Secure with clamp (H).
Note: The spray tube can be twisted and turned in the pleated hose with the handle. Ensure that all hose
and cable connections are safe and without sharp bends.
Place spray nozzle (15) on to spray tube (vertical to handle) and secure (I).
Push formula delivery hose (2 pieces) on nipple of the handle and to the spray nozzle. Secure the hose
alongside the pleated hose. Shut on/off tap (13) (vertical position), fill some plain water in formula tank and
check for any leakage.
To release the throttle control (17):
Hold the handle with your right hand,
 the throttle control lock (21) is activated by the flat of your
hand,  the throttle control is released.
Open liquid tap (13): Lever in horizontal position  ON
Shut liquid tap: Lever in vertical position  OFF
Stop switch (19) "I"  operating position
Stop switch "0"  engine off
8. Assembly
Important Components ; Assembly
ENGLISH 7