Remote Control Function - Leggett & Platt STYLE FOUNDATION DESIGN S-122 Manuel Du Propriétaire

FLASH LIGHT BUTTON
Press and hold to turn the flash light
ON. Release the button to turn the flash
UNDERBED LIGHT BUTTON
Press to turn on/off underbed light feature.
HEAD UP/DOWN BUTTON
Press and hold to raise or lower the
Press to adjust the base to the factory
default snore position. To reprogram,
adjust the base, massage, and underbed
light to the desired position, then
simultaneously press and hold the
Set button and Snore button until an
audible sound is heard, then release
HEAD MASSAGE INCREASE BUTTON
Press to turn on head massage. Press
again to increase massage intensity.
Massage turns off automatically after 15
HEAD MASSAGE DECREASE BUTTON
Once head massage is turned ON, press to
decrease massage intensity. Once massage
is at the lowest intensity, press again to
Use to program ZG, Snore, and Memory
Press to turn massage on in wave mode.
Press again to cycle through wave speeds.
REMOTE CONTROL REQUIRES (2) AAA SIZE BATTERIES. TO CONSERVE BATTERY
LIFE, THE TRANSMITTER TURNS OFF ALL FUNCTIONS WHEN ANY BUTTON IS
ZG, Snore, and Memory buttons:
To clear programmed settings and revert back to factory settings, simultaneously press and hold the HEAD DOWN button
and FLAT button until an audible sound is heard, then release buttons.
10

REMOTE CONTROL FUNCTION

light OFF.
head section.
SNORE BUTTON
both buttons.
minutes.
turn massage OFF.
SET BUTTON
presets.
WAVE BUTTON
PRESSED FOR MORE THAN 50 SECONDS.
LOCK BUTTON
To lock / unlock the remote control
buttons, press and hold lock button for 5
seconds. Backlight will flash 3 times.
DUAL UP BUTTON
Press and hold to simultaneously raise
the head and foot sections.
FOOT UP/DOWN BUTTON
Press and hold to raise or lower the foot
section.
FLAT BUTTON
Press to lower the base to the level
position. This button also turns off
massagers.
MEMORY BUTTON
Press to adjust the base to the factory
default memory position. To reprogram,
adjust the base, massage, and underbed
light to the desired position, then
simultaneously press and hold the Set
button and Memory button until an
audible sound is heard, then release
both buttons.
ZG (ZERO GRAVITY) BUTTON
Press to adjust the base to the factory
default ZG position. To reprogram, adjust
the base, massage, and underbed light to
the desired position, then simultaneously
press and hold the Set button and ZG
button until an audible sound is heard,
then release both buttons.
FOOT MASSAGE INCREASE BUTTON
Press to turn on foot massage. Press
again to increase massage intensity.
Massage turns off automatically after 15
minutes.
FOOT MASSAGE DECREASE BUTTON
Once foot massage is turned ON, press
to decrease massage intensity. Once
massage is at the lowest intensity, press
again to turn massage OFF.
NOTE