Installation Instructions - solamagic ARC Instructions De Montage Et D'utilisation

Installation instructions

External Dim Box ARC
The electrical connection may only be made by a trained electrician.
• Unscrew the control module from the wall bracket. To do so, undo both screws
with the 3 mm Allen key (1).
• Unscrew the four screws (2) at the connection module and fold out the connec-
tion module.
• Feed the supply cable through cable gland (3) and connect to the terminals
labelled L↑, N↑ and PE.
• Feed the outgoing cable through cable glands (4) and connect to the terminals
labelled L1↓, N↓ and PE.
• Tighten all cable glands with a 20 mm open ended spanner.
• Re-close the external dim box with the four screws (2) while ensuring the seal
is correctly seated.
• Fasten the wall bracket with suitable fastenings (not supplied - dependent on
the wall material) to the wall (observe the drilling template (5)). Insert the con-
trol module in the wall bracket and secure with the two M4x10 screws (1).

differentiation
4

inlet
3
2
PE PE L1 N N
2
1
PE PE L1 N
L1
PE L1 N
N L1
17
Drilling
connected
L
44
PE PE L1 N
12/2016