Scope Of Supply,Light Module Set S1; Installation Instructions, Light Module Set S1 - solamagic S1 Manuel D'instructions Et D'installation

Scope of supply,light module set S1

• Installation and instruction manual for light module set S1
• Light module set for for IR radiant heater S1
• Fastenings:
• 4 off Allen screws M4x10,
• 4 off serrated lock washer 4.3 mm,
• 1 off Allen key 3 mm,
• 1 set wire locating channel including 2 brackets

Installation instructions, light module set S1

• Do not open the connection module, all installation steps are performed from
outside.
• Pull the mains power lead
• Fit the light module set on the S1 radiant heater:
a) Mount the control module
heater and screw on to the Hirschmann plug connector side of the radiant
heater with an Allen screw M4x10 and a 4.3 mm serrated lock washer.
b) Mount the light module
screw on to the Hirschmann plug connector side of the radiant heater
with an Allen screw M4x10 and a 4.3 mm serrated lock washer.
c) F it the guide profile on the connecting cable and position on the inner
edge of the rear side of the radiant heaters. Push the retaining clips on to
the profile ends and screw tightly in place with an Allen screw M4x10 and
a serrated washer 4.3 mm inserted through each of the fastening holes
of the modules on the heater rear side.
• Insert the plug-in connector of the connection module in the panel connector of
the basic device.
• Plug the mains lead into the light module and switch on the power.
08/2016

out of the radiant heater

in the connection housing end of the radiant

one the opposite end of the radiant heater and
24

.