solamagic ARC Instructions De Montage Et D'utilisation page 21

Reprogramming
Selective
deleting Already programmed radiant heaters can be deleted and re-
programmed using the corresponding hand-held transmitter.
To do this press and hold buttons 1 and 2 of the hand-held
transmitter simultaneously (longer than 3 seconds) until the
control lamp on the hand-held transmitter illuminates. Deleti-
on is now enabled. Now release the buttons and immediately
press the button for approx. 1 sec., which the wireless receiver
was operated up until now.
The control lamp on the hand-held transmitter flickers off brief-
ly when the deletion signal is sent. The radiant heaters enter
an on-state and then switch off and on again. These receivers
can now be reprogrammed as described under „Program-
ming" above.
Complete
deletion:
Note:
This action deletes all receivers that are within range of the hand-held
transmitter.
Programmed wireless receivers can also be deleted (reset)
upon loss of a hand-held transmitter or if it becomes defective.
The deletion process is only possible within 180 seconds of
connection to the mains of the receiver in question. (If neces-
sary, disconnect the receiver from the mains and then recon-
nect.)
To delete, hold buttons 1 and 2 of the hand-held transmitter
pressed down (longer than 3 seconds). When doing so, the
red control lamp on the hand-held transmitter only illuminates
once deletion is enabled. Now release the buttons and imme-
diately afterwards press both buttons simultaneously for ap-
prox. 1 sec..
The control lamp on the hand-held transmitter flickers briefly
when the deletion signal is sent. The wireless receivers enter
the on-state and then switch off and on again. These receivers
can now be reprogrammed as described under „Program-
ming" above.
21
12/2016