Operation Guide; Program Enable - Ghost Mydmx Manuel

2 OPERATION GUIDE

GENERAL
This unit allows you to program 12 scanners of 16 DMX channels, 30 banks of 8 program-
mable scenes, 6 chases of 240 programmed scenes using 8 faders and other function
buttons. Up to 8 scenes can be programmed into a bank, and the amount of 240 pro-
grammed scenes can be stored into a chase and the scenes can be triggered by Music,
Auto, Tap Sync, MIDI and Manual.
Display Information
The Segment Display consists of 4 digits. The first digit shows the active chase num-
ber(1-6), the second digit shows the active scene number(1-8), and the third and forth
digits show the active bank number (01-30).
During Auto mode, a highlight in the lower right corner of the Segment Display next to
«Auto trigger» indicates its selection.
During Music mode, a highlight in the upper right corner of the Segment Display next to
«Music trigger» indicates its selection.
During Blackout mode, a fast blinking light indicates its selection in the upper left corner of
the Segment Display next to «Blackout».
During Program mode, a fast blinking light indicates its selection in the lower left corner of
the Segment Display next to «PROG.».
2.1

Program Enable

Step/time
Blackout Music trigger
Step
PROG
Chase Scene Bank
Auto trigger
Program
Page 32
When the power is turned on, this unit enters Manual mode
automatically.
Press the Program button for three seconds to activate Program
mode, a fast blinking light in the Segment Display next to «PROG.»
indicates its selection.