Care And Maintenance - Moen PureTouch 87810 Manuel Du Propriétaire

MICROTECH™ FILTER INSTALLATION
NOTE: Faucet will not operate in any mode without filter. Filter should be left in
protective bag until ready for installation. The MicroTech™ filter is a high
performance carbon block filter developed specially for the PureTouch Filtering
Faucet System. Once the filter is installed in the pullout spout, it should not be
removed until it is to be replaced. The electronic indicator keeps track of the
amount of filter life remaining and will signal you when the filter change is
necessary. If a partially used filter is removed and reinstalled, the electronic
indicator will automatically reset and will not accurately reflect filter life
remaining.
Use only MicroTech™ filter cartridges with the PureTouch Filtering Faucet System.
1. Remove the filter cover by lifting it up and away
from the pullout spout body.
2. Insert the new filter by aligning the outlet tubes
on the filter with the inlet ports of the spout
body and gently pressing in and down. Upon
successful installation of the filter cartridge, the
filter life indicator will beep three times and
reset automatically. (Do not remove the filter
until it is to be replaced.)
3. Reinstall the filter cover by positioning the
alignment tab with the corresponding notch in
the main pullout spout body and gently
pushing in and down.
4. Attach the pullout spout to the hose by
aligning the dots on the quarter turn connector
(18) and the spout. Push the quarter turn
connector onto the spout assembly and turn it
clockwise, locking it in place.
5. Allow cold water to run through the new filter
for 5 minutes to flush out any loose carbon
particles. (See page 9 for filtered water mode.)
Once these small black particles are washed
out the filter is ready for use.
The PureTouch System installation is now complete. Please read carefully the
operation instructions to ensure optimal performance.

CARE AND MAINTENANCE

All that is needed to clean your faucet is a soft damp cloth. Moen does not
recommend the use of scour pads, cleansers or chemicals. The abrasive nature
of these substances could damage the faucet's finish. A non abrasive car wax will
help to protect the finish. DO NOT PLACE WAND APPLIANCE IN DISHWASHER.
INS139 HELPLINE: 1-800-BUY-MOEN
ALIGN
DOTS
(2)
(3)
(4)
8