Installation Instructions - Bradley Sentry SN2005 Installation

Installation
1
Install and Anchor Unit
Rough-in of plumbing lines must be completed
before unit can be properly installed.
A Remove Access panel and with
the help of another person, place
unit in position .
Ensure unit is level, shimming floor unit if
B
necessary . Using the base as a template,
mark the floor anchor locations .
2
Connect Water Supply to Valve Assembly
WARNING! Do not turn on water until
Step 4 is completed!
Connect stops to hot and cold water supply .
A
Connect one end of each supply hose to a
stop and the other end to the hot and cold
inlets of the Navigator
Bradley • 215-1067 Rev. L; ECN 17-00-002
Water Supply
Gang Valve
Assembly
Navigator
(S01-526)
® TMV .
OPTIONAL TEMPERED LINE CONNECTION: Connect
B
stop to supply . Connect one end of the supply hose to the
stop and the other end to the tempered line adapter in the
gang valve assembly .
15" (381) Dia .
Install a minimum of four 3/8" bolts
C
(supplied by installer) around unit at the
marked locations (eight is recommended) .
Secure unit to floor .
Red Tube
(to Aerator)
Green Tube
(to Aerator)
Black Tube
(to Aerator)
Yellow Tube
(to Aerator)
Clear Tube
(to Aerator)
TMV
Cold Supply
Inlet
Stop Valve
8/21/2017
SN2005 - Infrared
Water Supply Gang
Valve Assembly
OPTIONAL
Tempered Line
Adapter Assembly
(S39-804)
Braided
Hose
Hot Supply Inlet
5