Storage; Disposal; Problems & Solutions - Inventum HNL4112Z Mode D'emploi

CAUTION
• Please note that the electric blanket should not be dry-cleaned, wrung out, machinedried, pressed or ironed.
In case of heavier soiling, this electric blanket can be washed in a washing machine. Set the washing machine to a particularly gentle,
30°C cycle (woollens programme). Use a wool laundry detergent and follow the manufacturer's instructions.
CAUTION
• Please note that excessive washing will wear out the electric blanket. For this reason, the electric blanket
should only be machine-washed a maximum of 5 times throughout its entire life.
Immediately after washing, reshape the electric underblanket to its original dimensions while it is still wet and spread it out flat over a
clothes horse to dry.
CAUTION
• Do not use pegs or similar items to attach the electric underblanket to the clothes horse. Otherwise, the electric
underblanket may be damaged.
Do not reconnect the controller to the electric underblanket until the plug-in connector and electric underblanket are completely dry.
Otherwise, the electric underblanket may be damaged.
6

storage

If you are not going to use the electric blanket for some time, we recommend storing it in its original packaging in a dry place without
weighing it down. For this purpose, disconnect the controller from the electric underblanket by unplugging the plug-in coupling.
CAUTION
Please allow the electric underblanket to cool down first.
Otherwise, the electric underblanket may be damaged. To avoid
sharp folds in the electric underblanket, do not place any objects
on top of it while it is being stored.
7

disposal

Legislation requires that all electrical and electronic equipment must be collected for reuse and recycling. Electrical and
electronic equipment marked with the symbol indicating separate collection of such equipment must be returned to a
municipal waste collection point.
8
problems & solutions
Display
The LEDs for the temperature settings 1, 3 and 5 blink.
The LEDs for the temperature settings 1, 3 and 5 still blink.
No LEDs light up even though
- the mains plug is connected to a functioning socket
- the controller is fully connected to the electric
underblanket via the plug-in connector
- the ON/OFF switch is set to the ON (I) position.
Cause
The controller is not fully
connected to the plug-in
connector of the electric
underblanket.
The device is faulty.
The device is faulty.
Action
Connect the plug-in connector fully.
Set the ON/OFF switch to the OFF
(0) position for 5 seconds. Then set it
back to the ON (I) position.
Send the complete transformer,
controller and electric
underblanket to the Service
Department.
Send the complete transformer,
controller and electric
underblanket to the Service
Department.
English
15
•