Forch GO-5001 Mode D'emploi page 35

■
Reassemble the cleaned / exchanged parts into the device. Place the pusher spring (6)
back onto the pusher (5) and put them back into the device at the place where there ist
he oil cylinder (11) as well:
■ Place the 3-pcs clamping jaw (4) into the clamping socket (3). Make sure that the 3 jaws
are placed into the right position:
■
Put the clamping socket (3) with the 3 clamping jaws (4) and the assembly pusher (5) into
their position. Make sure that all is well and tightly assembled.
■ Assemble the front socket (2) and the mouthpiece (1) back to the device: